(812) 842-3600
My Account
Quick Order
Orders@EvansvilleWeldingSupply.com
Weldmark WEM WMK52 Standard Duty Brass MIG Gun Diffuser 1.99 Inch 250 Amp
Item Code: 52.HG
Category
MIG Guns & Parts
- Easy identification - part no rolled stamped on the outside surface | Contains a conduit set screw used to hold the conduit liner in place | Machined from 360 brass alloy bar stock to ensure consistent dimensional stability | Designed to be used with Slip-on nozzle assemblies | A machined thread is on the outside surface to allow the nozzle insulator to thread over holding the Slip-on nozzle in place during the welding process | Recessed Tips are generally used for higher heat applications where longer electrical stick-out is required, or in cases where the nozzle may touch the work piece (tack, spot, and stitch) | Flush Tips are generally used where a shorter electrical stick-out is used sometimes resulting in shorter/tighter arc lengths, this brings the tip closer to the work piece | Protruding Tips are generally used when welding open root pipe or any joint that requires the welder to get into a tight weld joint | However the down side to this is the chance of arcing the tip to the work piece, which could damage front end parts resulting in downtime needed to replace
Description
selection not available, try a different combination
selection not available, try a different combination
Compare
Weldmark WEM WMK52 Standard Duty Brass MIG Gun Diffuser 1.99 Inch 250 Amp
Item Code: 52.HG
Category
MIG Guns & Parts
- Easy identification - part no rolled stamped on the outside surface | Contains a conduit set screw used to hold the conduit liner in place | Machined from 360 brass alloy bar stock to ensure consistent dimensional stability | Designed to be used with Slip-on nozzle assemblies | A machined thread is on the outside surface to allow the nozzle insulator to thread over holding the Slip-on nozzle in place during the welding process | Recessed Tips are generally used for higher heat applications where longer electrical stick-out is required, or in cases where the nozzle may touch the work piece (tack, spot, and stitch) | Flush Tips are generally used where a shorter electrical stick-out is used sometimes resulting in shorter/tighter arc lengths, this brings the tip closer to the work piece | Protruding Tips are generally used when welding open root pipe or any joint that requires the welder to get into a tight weld joint | However the down side to this is the chance of arcing the tip to the work piece, which could damage front end parts resulting in downtime needed to replace